2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2006


INSPECT FUEL INJECTOR ASSEMBLY

A158254E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      11.6 to 12.4 Ω at 20°C (68°F)

      If the result is not as specified, replace the fuel injector.

  1. Check the operation.

    CAUTION:
    Perform the inspection in a well-ventilated area.
    Do not perform the inspection near any naked flames.


    1. A088382E01
      Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).
      SST
      09268-41048   (90467-13001, 95336-08070, 09268-41500)

    2. Install the O-ring onto the fuel injector.

    3. A158255E01
      Connect SST (adapter and hose) to the fuel injector, and hold the fuel injector and union with SST (clamp).
      SST
      09268-41048   (09268-41110, 90467-13001, 95336-08070, 09268-41310)

    4. Set the fuel injector in a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector assembly to prevent gasoline splashes.

    5. Operate the fuel pump (Click here ).

    6. A075915E04
      Connect SST (wire) to the fuel injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      SST
      09842-30080  

      Injection volume:
      60 to 73 cm3 (3.7 to 4.5 cu in.) every 15 seconds

      Difference between each injector:
      13 cm3 (0.8 cu in.) or less

      NOTICE:
      Always do the switching at the battery side.

      If the injection volume is not as specified, replace the fuel injector.

  1. A116184
    Check the leakage.

    1. In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the fuel injector.

      Fuel drop:
      1 drop or less every 12 minutes

← REMOVAL (from Nov 2006)INSTALLATION (from Nov 2006) →