DTC P0016 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0016 | Deviation in crankshaft and camshaft position sensor signals (2 trip detection logic) |
|
| 1.CHECK VALVE TIMING (CHECK FOR LOOSE AND JUMPED TOOTH OF TIMING CHAIN) |
![]() |
Remove the cylinder head cover.
Turn the crankshaft pulley, and align its groove with the timing mark "0" on the timing chain cover.
Check that the timing marks on the camshaft timing sprocket and camshaft timing gear are facing upward as shown in the illustration.
Reinstall the cylinder head cover.
|
| ||||
| OK | |
| 2.REPLACE ECM |
|
| ||||
| 3.ADJUST VALVE TIMING |
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P0016) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear DTCs (Click here).
Switch the ECM from normal mode to check mode using the tester (Click here).
Start the engine and warm it up.
Allow the engine to idle for 1 minute or more, and then drive the vehicle for 1 minute or more.
Confirm that no DTC is set, using the tester.
| NEXT | ||
| ||