Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Yaw Rate Sensor Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Yaw Rate Sensor Communication Stop Mode
  1. "Yaw Rate / Deceleration Sensor" not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "Yaw Rate Sensor Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of yaw rate sensor
  2. Yaw rate sensor branch wire or connector
  3. Yaw rate sensor

HINT:
For vehicle with VSC only.


WIRING DIAGRAM


E191948E04


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
  4. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
  1. Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.CHECK CAN BUS LINE FOR DISCONNECTION (YAW RATE SENSOR BRANCH WIRE)


    E191965E06
  1. Turn the ignition switch off.

  1. Disconnect the D107 yaw rate sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D107-3 (CANH) - D107-2 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Yaw Rate Sensor)



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO YAW RATE SENSOR (CAN-H, CAN-L)
OK


2.CHECK HARNESS AND CONNECTOR (IG, GND)


    E191965E07
  1. Disconnect the D107 yaw rate sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D107-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D107-5 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Yaw Rate Sensor)
    Result 
    Result
    Proceed to
    OK
    (for Hatchback)
    A
    OK
    (for Sedan)
    B
    NG
    C



B
REPLACE YAW RATE SENSOR (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE YAW RATE SENSOR (Click here)