SFI SYSTEM > MIL Circuit |

| 1.CHECK THAT MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the table below.
| Conditions | Proceed To |
| MIL remains ON | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CHECK WHETHER MIL TURNS OFF |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Check if any DTCs have been stored. Note down any DTCs.
Clear DTCs (Click here).
Check if the MIL goes off.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the A21 ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
Reconnect the ECM connector.
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
![]() |
Disconnect the A21 ECM connector.
Disconnect the D2 combination meter connector (for Hatchback).
Disconnect the D84 combination meter connector (for Sedan).
Check the resistance.
| Tester Connections | Specified Conditions |
| W (A21-24) or combination meter (D2-4) or (D2-5) - Body ground | 10 kΩ or higher |
| W (A21-24) or combination meter (D84-4) - Body ground |
Reconnect the ECM connector.
Reconnect the combination meter connector.
|
| ||||
| NG | ||
| ||
| 5.CHECK THAT MIL IS ILLUMINATED |
Check if the MIL is illuminated when the ignition switch is turned to ON.
|
| ||||
| NG | |
| 6.CHECK THAT ENGINE STARTS |
Turn the ignition switch to ON.
Start the engine.
| Result | Proceed To |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 7.INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT) |
|
| ||||
| OK | ||
| ||