Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the SRS warning light.

HINT:
  1. Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communication system (Click here).
  2. When a warning light keeps blinking, a short to ground in the wiring of terminal TC of the DLC3 or an internal ground short in an ECU is suspected.
  3. The DTC output mode signal is transmitted through the CAN to each ECU including the center airbag sensor assembly. Thus when no systems enter DTC output mode, the ECM may have a malfunction.


WIRING DIAGRAM


C192922E01


C192923E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
H100899E03
  1. Turn the ignition switch off.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    D15-13 (TC) -
    A21-27 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TC OF DLC3 - TC OF ECM)
OK


2.CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND)


    F100115E84
  1. Measure the resistance.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    D15-4 (CG) -
    Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CG OF DLC3 - BODY GROUND)
OK


3.CHECK HARNESS AND CONNECTOR (TC OF ECM)


    A166552E02
  1. Measure the resistance.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    A21-27 (TC) -
    Body ground
    Always
    1 MΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ECM
  1. Replace the ECM.

  1. Check for DTCs of the ECM.

    HINT:
    1NZ-FE: (Click here )
    2NZ-FE: (Click here )

    Result:
    Result
    Proceed to
    Normal system code is output.
    A
    DTC is output.
    B
    DTC output mode is set (except center airbag sensor assembly).
    C



A
END

B
GO TO INSPECTION PROCEDURE OF DTC OUTPUT
C

REPLACE CENTER AIRBAG SENSOR ASSEMBLY