Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Hatchback)

ANTI-LOCK BRAKE SYSTEM (for Hatchback) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.

WIRING DIAGRAM


C188175E01

HINT:
When the warning lights continue to blink, there may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs.


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT DLC3


    C151827E37
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D15-13 (TC) - D15-4 (CG)
    Ignition switch ON
    11 to 14 V

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 5
A


3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)


    C158618E15
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Inspect the connector case and the terminal for deformation and corrosion.

    OK:
    No deformation or corrosion.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-13 (TC) - A21-27 (TC)
    Always
    Below 1 Ω
    D15-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    C151827E38
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT ECM (TC of DLC3 INPUT)


    C151827E37
  1. Turn the ignition switch off.

  1. Reconnect the ECM connector.

  1. Using SST, connect terminals TC and CG of the DLC3.

  1. Turn the ignition switch to ON.

  1. Check that the check engine warning light is blinking.
    Result 
    Result
    Proceed to
    Check engine warning light is blinking
    A
    Check engine warning light is not blinking (2NZ-FE)
    B
    Check engine warning light is not blinking (1NZ-FE)
    C



B
INSPECT SFI SYSTEM (Click here)

C
INSPECT SFI SYSTEM (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)