DTC C0278 Open in ABS Solenoid Relay Circuit |
DTC C0279 Short in ABS Solenoid Relay Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C0278 | When either of the following is detected:
|
|
| C0279 | Immediately after the ignition switch is turned to ON, the solenoid relay contact is closed for 4.5 seconds when the relay is turned off. |
|
| 1.INSPECT SKID CONTROL ECU (+BS TERMINAL) |
![]() |
Disconnect the skid control ECU connector.
Inspect the connector case and the terminal for deformation and corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-12 (+BS) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU (GND TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | ||
| ||