ANTI-LOCK BRAKE SYSTEM (for Hatchback) > TS and CG Terminal Circuit |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | |
| 2.INSPECT DLC3 |
![]() |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D15-12 (TS) - D15-4 (CG) | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (TS of DLC3 - POWER STEERING ECU) |
![]() |
Turn the ignition switch off.
Disconnect the power steering ECU connector.
Inspect the connector case and the terminal for deformation and corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D15-12 (TS) - D31-11 (TS) | Always | Below 1 Ω |
| D15-12 (TS) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D15-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT POWER STEERING ECU (TS of DLC3 INPUT) |
![]() |
Turn the ignition switch off.
Reconnect the power steering ECU connector.
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch to ON.
Check that the PS warning light is blinking.
| Result | Proceed to |
| Check PS warning light is blinking | A |
| Check PS warning light is not blinking | B |
|
| ||||
| A | ||
| ||