Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

In the Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM


C216253E08


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT DLC3


    C146309E21
  1. Turn the ignition switch to ON.
    Text in Illustration 
    *1
    Front view of DLC3

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D15-12 (TS) - D15-4 (CG)
    Ignition switch ON
    11 to 14 V

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 5
A


3.CHECK HARNESS AND CONNECTOR (TS of DLC3 - POWER STEERING ECU)
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-12 (TS) - D31-11 (TS)
    Always
    Below 1 Ω
    D15-12 (TS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    C146309E22
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Front view of DLC3

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK POWER STEERING ECU (TS of DLC3 INPUT)


    C146309E21
  1. Turn the ignition switch off.
    Text in Illustration 
    *1
    Front view of DLC3

  1. Reconnect the power steering ECU connector.

  1. Using SST, connect terminals TS and CG of the DLC3.

  1. Turn the ignition switch to ON.

  1. Check that the PS warning light is blinking.

    Result 
    Result
    Proceed to
    The PS warning light is blinking (for Sedan)
    A
    The PS warning light is blinking (for Hatchback)
    B
    The PS warning light is not blinking
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
CHECK POWER STEERING SYSTEM (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)