Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
In accordance with the following procedures, troubleshoot the audio and visual system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.BASIC INSPECTION
    1. Turn the ignition switch to ACC.

    2. Check whether the display appears on the radio receiver.
      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B



    B.
    PROCEED TO PROBLEM SYMPTOMS TABLE
    A


    4.DTC CHECK
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTC(s).

    3. Recheck for DTCs after reproducing the symptoms that caused the DTCs noted in step (a) above.
      Result
      Proceed to
      Display does not appear
      A
      Display appears
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. ON-Vehicle Inspection (Click here, Click here, Click here, Click here, Click here ,Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END