Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK BRAKE WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Check that the brake warning light comes on.

    OK:
    The brake warning light comes on.

    Result 
    Result
    Proceed to
    OK (for Sedan)
    A
    OK (for Hatchback)
    B
    NG
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
Go to step 3
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Reconnect the skid control ECU connector.

  1. Connect the intelligent tester to the DLC3.

  1. Perform Active Test of the combination meter using the intelligent tester.

    1. for Sedan (Click here).
    2. for Hatchback (Click here).

    OK:
    The brake warning light turns ON or OFF in accordance with the intelligent tester.

Result 
Result
Proceed to
OK (for Sedan)
A
OK (for Hatchback)
B
NG (for Sedan)
C
NG (for Hatchback)
D


B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)

D
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)