Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use this procedure to troubleshoot the engine immobiliser system.
The intelligent tester should be used in steps 4, 5 and 7.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.CRANK ENGINE FOR MORE THAN 10 SECONDS

        NEXT


        4.CHECK FOR DTCS
        1. Check for DTCs and note down any codes that are output.

        2. Clear the DTC.

        3. Recheck for DTCs. Based on the DTC output in (a), try to cause the output of the same SFI system DTC or engine immobiliser system DTC by simulating the original activity indicated by the DTC.

          1. If the DTC does not recur, proceed to A.

          2. If the SFI system or ECD system DTC recurs, proceed to B.

          3. If the engine immobiliser system DTC recurs, proceed to C.



        B.
        GO TO SFI SYSTEM (1NZ-FE)

        B.
        GO TO SFI SYSTEM (2NZ-FE)

        C.
        GO TO STEP 8
        A


        5.READ VALUE OF INTELLIGENT TESTER
        1. Connect the intelligent tester to the DLC3.

        2. Turn the ignition switch ON and push the intelligent tester main switch ON.

        3. On the intelligent tester, enter the following menus: Body/Immobiliser/Data List/Key SW. Read the result.

          Transponder key ECU assembly 
          Item
          Measurement Item/
          Display (Range)
          Normal Condition
          Diagnostic Note
          Key SW
          Unlock warning switch signal/
          ON or OFF
          OFF: No key is in ignition key cylinder
          ON: Key is in ignition key cylinder
          -

          OK:
          "ON" (key is in ignition key cylinder) appears on the screen.



        NG.
        GO TO DTC B2780
        OK


        6.PROBLEM SYMPTOMS TABLE
        1. If the fault is not listed on the problem symptoms table, proceed to A.

        2. If the fault is listed on the problem symptoms table, proceed to B.



        B.
        GO TO STEP 8
        A


        7.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Data List/Active Test (Click here)

          1. Inspection using the intelligent tester (Data List)

          2. Inspection using the intelligent tester (Active Test)

        2. Terminals of ECU (Click here)


        NEXT


        8.ADJUST, REPAIR OR REPLACE

          NEXT


          9.CONFIRMATION TEST

            NEXT

            END