Home › ENGINE · 1NZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > VC Output Circuit

for Preparation Click here


DESCRIPTION

The ECM constantly generates 5 V power from the battery voltages supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit.

A116143E09

When the VC circuit is short-circuited, the microprocessor in the ECM and sensors that are supplied with power through the VC circuit are inactivated because the power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.

HINT:
Under normal conditions, the MIL is illuminated for several seconds when the ignition switch is first turned to ON. The MIL goes off when the engine is started.


WIRING DIAGRAM


A115682E01


INSPECTION PROCEDURE

1.CHECK MIL
  1. Check that Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to ON.

    OK:
    MIL lights up



OK
SYSTEM OK
NG


2.CHECK COMMUNICATION BETWEEN INTELLIGENT TESTER AND ECM
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and tester on.

  1. Check the communication between the tester and ECM.

    Result:
    Result
    Proceed To
    Communication is possible
    A
    Communication is not possible
    B



A
GO TO MIL CIRCUIT (Click here)
B


3.CHECK MIL (THROTTLE POSITION SENSOR)
  1. Disconnect the C17 throttle body connector.

  1. Turn the ignition switch to ON.

  1. Check the MIL.

    Result:
    Result
    Proceed To
    MIL illuminates
    A
    MIL does not illuminate
    B

  1. Reconnect the throttle body connector.



A
REPLACE THROTTLE BODY ASSEMBLY (Click here)
B


4.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR)
  1. Disconnect the A20 accelerator pedal position sensor connector.

  1. Turn the ignition switch to ON.

  1. Check the MIL.

    Result:
    Result
    Proceed To
    MIL illuminates
    A
    MIL does not illuminate
    B

  1. Reconnect the accelerator pedal position sensor connector.



A
REPLACE ACCELERATOR PEDAL POSITION SENSOR (Click here)
B


5.CHECK HARNESS AND CONNECTOR (VC OUTPUT CIRCUIT)
  1. Disconnect the C17 throttle body connector.

  1. Disconnect the A20 accelerator pedal position sensor connector.



    A107934E11
  1. Disconnect the A21 and C20 ECM connectors.

  1. Check the resistance.

    Standard resistance (Check for short):
    Tester Connections
    Specified Conditions
    VCTA (C20-67) - Body ground
    10 kΩ or higher
    VCPA (A21-57) - Body ground
    VCP2 (A21-58) - Body ground

  1. Reconnect the throttle body connector.

  1. Reconnect the accelerator pedal position sensor connector.

  1. Reconnect the ECM connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)