FRONT AXLE HUB (for Hatchback) > INSTALLATION |
| 1. INSTALL FRONT AXLE ASSEMBLY |
![]() |
Install the front axle assembly onto the shock absorber.
Install the 2 bolts and 2 nuts.
Push the front axle out of the vehicle to align the spline of the drive shaft with the front axle and insert the front axle.
| 2. INSTALL FRONT SUSPENSION LOWER ARM |
![]() |
Install the lower arm onto the steering knuckle with a new castle nut.
Install a new clip.
| 3. INSTALL FRONT STABILIZER LINK ASSEMBLY |
![]() |
Install the stabilizer link with the nut.
| 4. INSTALL TIE ROD END SUB-ASSEMBLY |
![]() |
Install the tie rod end onto the steering knuckle with a new castle nut.
Install a new cotter pin.
| 5. INSTALL FRONT DISC |
![]() |
Align the matchmarks of the disc and axle hub and install the disc.
| 6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the disc brake caliper onto the steering knuckle.
| 7. INSTALL FRONT SPEED SENSOR (w/ ABS) |
![]() |
Install the speed sensor onto the steering knuckle with the bolt.
![]() |
Install the flexible hose and speed sensor with the bolt.
| 8. INSTALL FRONT AXLE HUB NUT |
![]() |
Using a 30 mm socket wrench, install a new axle hub nut.
Using a chisel and hammer, stake the axle hub nut.
| 9. INSPECT FRONT AXLE HUB BEARING |
Remove the front wheel.
Separate the disc brake caliper .
Remove the front disc .
![]() |
Inspect the axle hub backlash.
Using a dial indicator, check the backlash near the center of the axle hub.
![]() |
Inspect the axle hub runout.
Using a dial indicator, check the runout of the surface of the axle hub.
Install the front disc .
Install the disc brake caliper .
Install the front wheel.
| 10. INSTALL FRONT WHEEL |
| 11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the front wheel alignment (Click here).
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. CHECK SPEED SENSOR SIGNAL (w/o VSC) |
Check the ABS sensor signal (Click here).
| 14. CHECK SPEED SENSOR SIGNAL (w/ VSC) |
Check the ABS sensor signal (Click here).