Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Inspect the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN Communication System is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (except Separate Type Yaw Rate Sensor)
      B
      CAN DTC is output (for Separate Type Yaw Rate Sensor)
      C



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)

    C.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs. Based on the DTCs output above, try to force output of the A/C system DTC by simulating the operation indicated by the DTC.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Panel diagnosis (refrigerant shortage check) (Click here)*1
      *1: w/ Cooler

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)

    4. On-Vehicle Inspection

    5. Inspection

    6. Check for DTCs after checking harness and connector (Click here).


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT

      END