DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in ECM back-up power source circuit (1 trip detection logic) |
|
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| Stand-by RAM | Initialized |
| ECM power source | Below 3.5 V |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT BATTERY |
Inspect that the battery is not depleted .
|
| ||||
| OK | |
| 2.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 3.INSPECT ECM (BATT TERMINAL VOLTAGE) |
![]() |
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A74-20 (BATT) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to ECM) |
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | |
| 4.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - ECM) |
Disconnect the ECM connector.
Remove the No. 1 integration relay from engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1E-9 - A74-20 (BATT) | Always | Below 1 Ω |
| 1E-9 or A74-20 (BATT) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - BATTERY) |
Remove the No. 1 integration relay from engine room relay block.
Disconnect the negative (-) battery terminal.
Disconnect the positive (+) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - Battery positive terminal | Always | Below 1 Ω |
| 1C-1 or Battery positive terminal - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT NO. 1 INTEGRATION RELAY |
Inspect the No. 1 integration relay (Click here).
|
| ||||
| OK | |
| 7.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear DTCs (Click here).
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Turn the tester on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0560 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||