STEERING COLUMN ASSEMBLY (for LHD) > INSTALLATION |
| 1. INSTALL STEERING COLUMN ASSEMBLY |
Install the steering column assembly onto the instrument panel reinforcement assembly with the 2 nuts and a new bolt.
Connect all the connectors and clamp the wire harnesses onto the steering column assembly bracket.
Install the wire harness clamp to the power steering ECU assembly.
Connect the 2 steering column assembly connectors to the power steering ECU assembly.
| 2. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY |
![]() |
Tighten the bolt C while aligning the No. 2 steering intermediate shaft assembly with the position D as shown in the illustration.
| *1 | Steering Sliding Yoke Sub-assembly |
| *2 | No. 2 Steering Intermediate Shaft Assembly |
| *a | Matchmark |
| *b | Front of the Vehicle |
Align the matchmarks on the steering sliding yoke sub-assembly and the steering gear assembly.
Install bolt B.
Tighten bolt A.
| 3. INSTALL COLUMN HOLE COVER SILENCER SHEET |
Install the column hole cover silencer sheet with the 2 clips.
Install the floor carpet.
| 4. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY |
| 5. INSTALL COMBINATION SWITCH ASSEMBLY |
Install the combination switch assembly onto the steering column assembly with the clamp.
Connect all the connectors to the combination switch assembly.
| 6. INSTALL UPPER STEERING COLUMN COVER |
Engage the claw to install the upper steering column cover.
| 7. INSTALL LOWER STEERING COLUMN COVER |
Engage the 4 claws to install the lower steering column cover.
Install the 3 screws.
| 8. INSTALL STEERING WHEEL ASSEMBLY |
Align the matchmarks and install the steering wheel assembly onto the steering column assembly.
Install the nut.
Connect all the connectors to the spiral cable.
| 9. INSTALL STEERING PAD |
| 10. POSITION FRONT WHEELS FACING STRAIGHT AHEAD |
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT SRS WARNING LIGHT |
| 13. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT |