Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. REMOVE COMBINATION METER ASSEMBLY
(Click here)


2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)


    B284273
  1. Disengage the 5 clips and the 2 claws and remove the instrument panel finish panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


  1. for LHD:



      B284274
    1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



  1. for RHD:



      B272572
    1. Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



5. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


6. REMOVE STOP LIGHT SWITCH ASSEMBLY


C233915
  1. Disconnect the connector from the stop light switch assembly.

  1. Disengage the harness clamp from the pedal support.



    C233916
  1. Turn the stop light switch counterclockwise and remove the stop light switch assembly.



7. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


C233917
  1. Remove the brake pedal return spring.

  1. Remove the clip and push rod pin and separate the push rod clevis from the brake pedal.



8. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for LHD)


C234878E02
  1. Place matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen bolt A.

  1. Remove bolt B and separate the No. 2 steering intermediate shaft assembly from the steering column assembly.



9. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)


    C241861
  1. Remove the 4 nuts, bolt and the pedal support.



10. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for RHD)
  1. Remove the wire harness clamp.



    B170208
  1. Remove the 4 nuts, bolt and the pedal support.