Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for RHD)

STEERING COLUMN ASSEMBLY (for RHD) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE STEERING PAD
(Click here)


4. REMOVE STEERING WHEEL ASSEMBLY


    C241422E01
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and the steering main shaft.
    Text in Illustration 
    *a
    Matchmark

  1. Disconnect the connectors from the spiral cable.



    C241423E01
  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.



5. REMOVE LOWER STEERING COLUMN COVER


    C232521
  1. Remove the 3 screws, disengage the 4 claws, release the tilt lever and remove the lower steering column cover.



6. REMOVE UPPER STEERING COLUMN COVER


    C232522
  1. Disengage the claw and remove the upper steering column cover.



7. REMOVE COMBINATION SWITCH ASSEMBLY
  1. Disconnect all connectors from the combination switch assembly.



    C233274E01
  1. Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly from the steering column assembly.
    Text in Illustration 
    *a
    Loosen The Clamp
    *b
    Raise The Claw



8. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY
(Click here)


9. REMOVE COLUMN HOLE COVER SILENCER SHEET


    C234877
  1. Remove the floor carpet and 2 clips and remove the column hole cover silencer sheet.



10. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY


    C205442E03
  1. Place matchmarks on the No. 2 steering intermediate shaft assembly and the steering column assembly.
    Text in Illustration 
    *1
    No. 2 Steering Intermediate Shaft Assembly
    *2
    Steering Sliding Yoke Sub-assembly
    *a
    Matchmark

  1. Place matchmarks on the steering sliding yoke sub-assembly and the steering gear assembly.

  1. Loosen bolt A.

  1. Loosen bolt C.

  1. Remove bolt B and detach the steering sliding yoke sub-assembly from the steering gear assembly.



11. REMOVE STEERING COLUMN ASSEMBLY


    C233275
  1. Separate the wire harness clamp from the power steering ECU assembly.

  1. Disconnect the 2 steering column assembly connectors from the power steering ECU assembly.

  1. Disconnect all connectors and detach all wire harness clamps from the steering column assembly.



    C232524
  1. Remove the bolt, the 2 nuts and the steering column assembly from the instrument panel reinforcement assembly.