Home › Audio/Visual/Telematics › AUDIO / VIDEO › QUARTER TRIM SPEAKER

QUARTER TRIM SPEAKER > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPEAKER ASSEMBLY


    E229055E01
  1. Using an air riveter or hand riveter, install the rear speaker assembly onto the quarter panel with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. B130465
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. B130466
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B130467
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.

  1. Connect the connector.



2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
  1. Engage the 8 clips and the 10 claws.

  1. Engage the 3 guides and install the quarter trim panel.



3. INSTALL FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY
  1. Connect the floor anchor part of the front seat outer belt assembly and install the front seat belt outer bar sub-assembly with the 2 bolts.

    Torque:
    41 N*m{ 420 kgf*cm , 30 ft.*lbf }



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Install the front door opening trim weatherstrip.



5. INSTALL FRONT DOOR SCUFF PLATE
  1. Engage the 8 claws and install the front door scuff plate.



6. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


7. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


8. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)