AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor) > TC and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM) |
![]() |
Turn the ignition switch off.
Disconnect the connector from the ECM.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F4-13 (TC) - A74-27 (TC) | Always | Below 1 Ω |
| *1 | DLC3 |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F4-4 (CG) - Body ground | Always | Below 1 Ω |
| *1 | DLC3 |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TC OF ECM) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A74-27 (TC) - Body ground | Always | 1 MΩ or higher |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM.
Check for DTCs of the ECM.
| Result | Proceed to |
| Normal code is output | A |
| DTC is output (for 1NZ-FE) | B |
| DTC is output (for 2NZ-FE) | C |
| DTC output mode is set (except airbag sensor assembly) | E |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||