Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor)

VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor) > ABS Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the skid control ECU, perform zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

Result 
Result
Proceed to
DTC is not output
A
DTC is output
B


B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK ABS WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Check that the ABS warning light comes on.

Result 
Result
Proceed to
NG
A
OK
B
  1. Reconnect the skid control ECU connector.



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A


3.READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

  1. According to the display on the tester, read the Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ABS Warning Light
    ABS warning light/OFF or ON
    OFF: Warning light off
    ON: Warning light on
    -

  1. When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.


ABS/VSC/TRC 
Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Light
ABS warning light
Warning light OFF/ON
Observe combination meter
[Vehicle condition]
Vehicle stopped

Result 
Result
Proceed to
Data List Display
Data List Display when Performing Active Test ON/OFF Operation
ON
Changes between ON and OFF
A
Does not change between ON and OFF
B
OFF
Changes between ON and OFF
A
Does not change between ON and OFF
B


B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)