Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor)

VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor) > Brake Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the skid control ECU, perform zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

Result 
Result
Proceed to
DTC is not output
A
DTC is output
B


B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK BRAKE WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Check that the brake warning light comes on.

  1. Reconnect the skid control ECU connector.



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.READ VALUE USING INTELLIGENT TESTER (BRAKE WARNING LIGHT)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

  1. According to the display on the tester, read the Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Brake Warning Light
    Brake warning light/OFF or ON
    OFF: Warning light off
    ON: Warning light on
    -

  1. When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.


ABS/VSC/TRC 
Tester Display
Test Part
Control Range
Diagnostic Note
Brake Warning Light
Brake warning light
Warning light OFF/ON
Observe combination meter
[Vehicle condition]
Vehicle stopped

Result 
Result
Proceed to
Data List Display
Data List Display when Performing Active Test ON/OFF Operation
ON
Changes between ON and OFF
A
Does not change between ON and OFF
B
OFF
Changes between ON and OFF
A
Does not change between ON and OFF
B
  1. Connect the intelligent tester to the DLC3.



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)