VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor) > Slip Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK SLIP INDICATOR LIGHT |
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the Slip indicator light comes on.
|
| ||||
| OK | ||
| ||
| 3.READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Slip Indicator Light | SLIP indicator light/OFF or ON | OFF: Indicator light off ON: Indicator light on | - |
When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slip Indicator Light | Slip indicator light | Indicator light OFF/ON | Observe combination meter [Vehicle condition] Vehicle stopped |
| Result | Proceed to | |
| Data List Display | Data List Display when Performing Active Test ON/OFF Operation | |
| ON | Changes between ON and OFF | A |
| Does not change between ON and OFF | B | |
| OFF | Changes between ON and OFF | A |
| Does not change between ON and OFF | B | |
|
| ||||
| A | ||
| ||