Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

E219866E11


Text in Illustration 
*1
Instrument Panel Junction Block Assembly
*2
Main Body ECU
  1. Remove the main body ECU from the instrument panel junction block assembly (Click here).

  2. Disconnect the F76 main body ECU connector.

  3. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    MB-11 (GND1) - Body ground
    None - Body ground
    Ground
    Always
    Below 1 Ω
    MB-30 (BECU) - Body ground
    None - Body ground
    Battery power supply
    Always
    11 to 14 V
    MB-31 (ALTB) - Body ground
    None - Body ground
    Battery power supply
    Always
    11 to 14 V
    MB-29 (ACC) - Body ground
    None - Body ground
    ACC power supply
    Ignition switch on (ACC)
    11 to 14 V
    MB-32 (IG) - Body ground
    None - Body ground
    Ignition switch power supply
    Ignition switch on (IG)
    11 to 14 V
    F76-17 (KSW) - Body ground
    Y - Body ground
    Unlock warning switch input
    No Key in ignition key cylinder (off)
    10 kΩ or higher
    Key inserted ignition key cylinder (on)
    Below 1 Ω

  4. Install the main body ECU to the instrument panel junction block assembly (Click here).

  5. Reconnect the F76 main body ECU connector.

  6. Measure the voltage and check for pulse according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    3D-36 (FLCY) - Body ground
    L - Body ground
    Front door LH courtesy light switch input
    Front door LH open
    Below 1 V
    Front door LH closed
    Pulse generation
    F76-17 (KSW) - Body ground
    Y - Body ground
    Unlock warning switch input
    No Key in ignition key cylinder (off)
    11 to 14 V
    Key inserted ignition key cylinder (on)
    Below 1 V