Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Door Unlock Detection Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU detects the condition of each door unlock detection switch.

WIRING DIAGRAM


E231472E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Door Lock Pos
    Front door unlock detection switch RH signal /
    LOCK or UNLOCK
    LOCK: Front door RH locked
    UNLOCK: Front door RH unlocked
    -
    FL Door Lock Pos
    Front door unlock detection switch LH signal /
    LOCK or UNLOCK
    LOCK: Front door LH locked
    UNLOCK: Front door LH unlocked
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT FRONT DOOR LOCK ASSEMBLY
  1. Inspect the front door lock assembly (Click here).



NG
REPLACE FRONT DOOR LOCK ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK ASSEMBLY - MAIN BODY ECU AND BODY GROUND)
  1. for LHD

    1. Disconnect the H5 front door lock assembly LH connector.

  1. for RHD

    1. Disconnect the G5 front door lock assembly RH connector.

  1. Disconnect the F76 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    H5-8 (LSSR) - F76-7 (LSFL)
    Always
    Below 1 Ω
    H5-8 (LSSR) - Body ground
    Always
    10 kΩ or higher
    H5-7 (E) - Body ground
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    G5-7 (LSSR) - F76-18 (LSFR)
    Always
    Below 1 Ω
    G5-7 (LSSR) - Body ground
    Always
    10 kΩ or higher
    G5-8 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (Click here)