Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the power window control system.
  2. *: Use the Intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    4.CHECK LIN COMMUNICATION SYSTEM*
    1. Use the Intelligent tester to check if the LIN communication system is functioning.
      Result 
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Data List / Active Test (Click here).

    3. Terminals of ECU (Click here).


    NEXT


    8.REPAIR OR REPLACE
      Result 
      Result
      Proceed to
      Door window regulator replaced or removed/installed
      A
      Door window regulator not replaced or removed/installed
      B


    B.
    Go to step 10
    A


    9.INITIALIZE POWER WINDOW MOTOR
    1. If a power window regulator switch LED is blinking, initialize the power window regulator (Click here).


    NEXT


    10.CONFIRMATION TEST

      NEXT

      END