1NZ-FE SFI SYSTEM > VC Output Circuit |


| 1.CHECK MIL CONDITION |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to ON.
|
| ||||
| OK | ||
| ||
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Check for communication between the tester and ECM.
| Result | Proceed to |
| Communication is not possible | A |
| Communication is possible | B |
|
| ||||
| A | |
| 3.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the throttle with motor body assembly connector.
Turn the ignition switch to ON.
Check the MIL.
| Result | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 4.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the accelerator pedal sensor assembly connector.
Turn the ignition switch to ON.
Check the MIL.
| Result | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (VC CIRCUIT) |
Disconnect the throttle with motor body assembly connector.
Disconnect the accelerator pedal sensor assembly connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B84-67 (VCTA) or B29-5 (VC) - Body ground | Always | 10 kΩ or higher |
| A74-57 (VCPA) or A36-4 (VCPA) - Body ground | Always | 10 kΩ or higher |
| A74-58 (VCP2) or A36-1 (VCP2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||