VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor) > VSC OFF Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (CSW TERMINAL) |
Turn the ignition switch off.
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A54-30 (CSW) - Body ground | VSC OFF Switch held on | Below 1 Ω |
| A54-30 (CSW) - Body ground | VSC OFF Switch off (Not pressed) | 10 kΩ or higher |
| *a | Front view of wire harness connector (to skid control ECU) |
Reconnect the skid control ECU connector.
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| TRC/VSC Off Mode | TRC/VSC off mode/Normal, TRC OFF, Unknown or VSC OFF | Normal: Normal mode TRC OFF: TRC OFF mode Unknown: Unspecified VSC OFF: TRC, VSC OFF mode | - |
Check that the mode display changes according to the VSC OFF switch operation.
|
| ||||
| OK | ||
| ||
| 4.INSPECT VSC OFF SWITCH |
Remove the VSC OFF switch (Click here).
Inspect the VSC OFF switch (Click here).
Reconnect the VSC OFF switch connector.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Disconnect the skid control ECU (brake actuator assembly) connector and the VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A54-30 (CSW) - F57-6 | Always | Below 1 Ω |
| F57-3 - Body ground | Always | Below 1 Ω |
| A54-30 (CSW) - Body ground | Always | 10 kΩ or higher |
Reconnect the skid control ECU (brake actuator assembly) connector and the VSC OFF switch connector.
|
| ||||
| OK | ||
| ||