REAR SEAT OUTER BELT ASSEMBLY (for 3 Door) > REMOVAL |
| 1. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 3. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 4. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board.
| 5. REMOVE SPARE WHEEL COVER |
![]() |
Remove the spare wheel cover.
| 6. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
| *1 | Protective Tape |
Disconnect the connector and remove the No. 2 room light assembly.
| 7. REMOVE JACK HANDLE (for RH Side) |
| 8. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Disengage the 4 claws and 4 guides and remove the rear floor finish plate.
| 9. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 8 claws and remove the front door scuff plate.
| 10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Remove the front door opening trim weatherstrip.
| 11. REMOVE FRONT SEAT BELT OUTER BAR SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and front seat belt outer bar sub-assembly, disconnect the floor anchor part of the front seat outer belt assembly.
| 12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY |
![]() |
Disengage the 8 clips and 10 claws.
Disengage the 3 guides and remove the quarter trim panel.
| 13. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
![]() |
Remove the bolt.
Disengage the 2 claws and separate the rear seat 3 point type outer belt.
| 14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) |
![]() |
Remove the 3 screws.
Disengage the 3 clips and the 3 claws and remove the deck trim side panel.
| 15. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) |
| 16. REMOVE ROOF SIDE INNER GARNISH |
![]() |
Disengage the 5 clips.
Pass the rear seat 3 point type outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.
| 17. REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
![]() |
Remove the bolt and the shoulder anchor part of the rear seat 3 point type outer belt assembly.
![]() |
Remove the bolt, disengage the 2 hooks to remove the rear seat 3 point type outer belt assembly.
| 18. REMOVE SEAT BELT HOLE SEAL |
![]() |
Disengage the 2 claws to remove the seat belt hole seal.