REAR SEAT OUTER BELT ASSEMBLY (for 5 Door) > INSTALLATION |
| 1. INSTALL SEAT BELT HOLE SEAL |
Engage the 2 claws to install the seat belt hole seal.
| 2. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
![]() |
Check the angle of inclination required to lock the retractor.
| *a | Lock |
| *b | Unlock |
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
Engage the 2 hooks to install the rear seat 3 point type outer belt assembly.
Install the bolt.
Install the shoulder anchor part of the rear seat 3 point type belt assembly with the bolt.
Engage the 2 claws and install the floor anchor part of the rear seat 3 point type belt assembly with the bolt.
Check that the ELR locks.
With the belt installed, check that the belt locks when it is pulled out quickly.
Remove the bolt and disconnect the 2 claws and the floor anchor part of the rear seat 3 point type belt assembly.
| 3. INSTALL ROOF SIDE INNER GARNISH |
Pass the rear seat 3 point type outer belt through the slit in the roof side inner garnish.
Engage the 4 clips and install the roof side inner garnish.
| 4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) |
Engage the 3 clips.
Engage the guide and the 4 claws and install the deck trim side panel.
Install the 3 screws.
| 5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) |
| 6. CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
Engage the 2 claws and install the rear seat 3 point type outer belt.
Tighten the bolt.
| 7. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the paint mark on the rear door opening trim weatherstrip with the flange position on the vehicle body and install the weatherstrip.
| *a | Paint Mark |
| *b | Flange Position |
| Area | Color |
| RH Side | Purple |
| LH Side | Pink |
| 8. INSTALL REAR DOOR SCUFF PLATE |
Engage the guide and the 5 claws and install the rear door scuff plate.
| 9. INSTALL REAR FLOOR FINISH PLATE |
Engage the 4 guides and the 4 claws to install the rear floor finish plate.
| 10. INSTALL JACK HANDLE (for RH Side) |
| 11. INSTALL NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light) |
Connect the connector.
![]() |
Engage the claw to install the No. 2 room light assembly.
| 12. INSTALL SPARE WHEEL COVER |
Install the spare wheel cover.
| 13. INSTALL DECK BOARD ASSEMBLY |
Install the deck board.
| 14. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 15. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 16. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |