Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

In this circuit, the meter CPU receives engine speed signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays the engine speed calculated based on the data received from the ECM.

WIRING DIAGRAM


E143765E56


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output.

    1. except Separate Type Yaw Rate Sensor (Click here)
    1. for Separate Type Yaw Rate Sensor (Click here)
    Result 
    Result
    Proceed to
    CAN communication DTC is not output
    A
    CAN communication DTC is output (except Separate Type Yaw Rate Sensor)
    B
    CAN communication DTC is output (for Separate Type Yaw Rate Sensor)
    C



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TACHOMETER OPERATION)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    TachoMeter Operation
    Tachometer
    OFF/0/1000/2000/3000/4000/5000/6000/7000 rpm
    Perform the test with the vehicle stopped and the engine idling.

    OK:
    Tachometer indication is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING INTELLIGENT TESTER (ENGINE RPM)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed/
    Min.: 0
    Max.: 12750
    Approximately same as actual engine speed (when engine is running)
    Unit: rpm

    OK:
    Engine speed displayed on the intelligent tester is almost the same as the tachometer indication.

    HINT:
    Check the engine speed when the engine is fully warmed up, and the air conditioning and all electrical accessories are off.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


4.CHECK ENGINE CONTROL SYSTEM
  1. Check if a engine control DTC is output.

    1. for 2NZ-FE (Click here).
    2. for 1NZ-FE (Click here).
    Result 
    Result
    Proceed to
    Engine control DTC is not output
    A
    Engine control DTC is output (for 2NZ-FE)
    B
    Engine control DTC is output (for 1NZ-FE)
    C



B
GO TO SFI SYSTEM (Click here)

C
GO TO SFI SYSTEM (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)