POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK DTC AND FREEZE FRAME DATA* |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occurs | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK CAN COMMUNICATION SYSTEM* |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output (except Separate Type Yaw Rate Sensor) | B |
| CAN communication system DTC is output (for Separate Type Yaw Rate Sensor) | C |
|
| ||||
|
| ||||
| |||||
| 7.CHECK FOR DTC* |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 9.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Refer to Terminals of ECU (Click here).
Refer to Data List/Active Test (Click here).
| |||||
| 10.REPAIR OR REPLACE |
| |||||
| 11.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|