Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1582    Assist Map Number Mismatch

for Preparation Click here


DESCRIPTION

When an incorrect ECM is installed after the assist map has been recorded in the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.

DTC No.
DTC Detection Condition
Trouble Area
C1582
Assist map number mismatch
  1. Power steering ECU assembly
  2. CAN communication system
  3. ECM

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs of the CAN communication system.
    Yaw Rate Sensor Type
    See Page
    except Separate Type Yaw Rate Sensor
    Click here
    for Separate Type Yaw Rate Sensor
    Click here
    Result 
    Result
    Proceed to
    DTCs is not output
    A
    DTCs is output (except Separate Type Yaw Rate Sensor)
    B
    DTCs is output (for Separate Type Yaw Rate Sensor)
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.CHECK ECM
  1. Check if an ECM that complies with the vehicle specifications is installed.

    OK:
    The ECM that complies with vehicle specifications is installed.

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG (for 1NZ-FE)
    C
    NG (for 2NZ-FE)
    D



B
REPLACE POWER STEERING ECU ASSEMBLY (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)