POWER WINDOW CONTROL SYSTEM > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) |
| 1.PERFORM INITIALIZATION (DRIVER SIDE) |
Initialize the power window regulator motor assembly LH or RH (driver side) (Click here).
| NEXT | |
| 2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (DRIVER SIDE)) |
Check that the driver side power window move when the auto up and down function of the power window regulator master switch assembly and are operated (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK WINDOW GLASS SLIDING MOVEMENT (DRIVER SIDE) |
Remove the window regulator.
Install the window glass onto the door glass run.
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
|
| ||||
| OK | ||
| ||