Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for 3 Door)

FRONT SEAT OUTER BELT ASSEMBLY (for 3 Door) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


4. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


5. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)


6. REMOVE FRONT DOOR SCUFF PLATE


    B284313
  1. Disengage the 8 claws and remove the front door scuff plate.



7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B284315
  1. Remove the front door opening trim weatherstrip.



8. REMOVE FRONT SEAT BELT OUTER BAR SUB-ASSEMBLY


    B282674
  1. Remove the 2 bolts and front seat belt outer bar sub-assembly, disconnect the floor anchor part of the front seat outer belt assembly.



9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY


    B284318
  1. Disengage the 8 clips and 10 claws.

  1. Disengage the 3 guides and remove the quarter trim panel.



10. REMOVE CENTER PILLAR UPPER GARNISH


    B284319
  1. Remove the 2 screws and disengage the clip.

  1. Pass the front seat outer belt through the slit in the center pillar upper garnish and remove the center pillar upper garnish.



11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B282671
  1. Remove the bolt and the shoulder anchor part of the front seat outer belt assembly.



    B282672E01
  1. Using a screwdriver with its tip wrapped in protective tape, release the locking button.

  1. Disconnect the pretensioner connector.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Locking Button



    B282673
  1. Remove the 2 bolts.

  1. Disengage the 2 hooks and remove the front seat outer belt assembly.