Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (for 5 Door)

DOOR CONTROL RECEIVER (for 5 Door) > INSTALLATION

for Preparation Click here



1. INSTALL DOOR CONTROL RECEIVER
  1. Engage the 2 hooks.

  1. Install the door control receiver with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. INSTALL ROOF SIDE INNER GARNISH LH

HINT:
Use the same procedure as for the RH side



3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

HINT:
Use the same procedure as for the RH side



4. INSTALL NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
  1. Connect the connector.



    E222046
  1. Engage the claw to install the No. 2 room light assembly.



5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Install the rear door opening trim weatherstrip.



6. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

HINT:
Use the same procedure as for the RH side



7. INSTALL REAR FLOOR FINISH PLATE
  1. Engage the 4 guides and the 4 claws to install the rear floor finish plate.



8. INSTALL REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



9. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


10. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


11. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)


12. INSTALL SPARE WHEEL COVER
  1. Install the spare wheel cover.



13. INSTALL DECK BOARD ASSEMBLY
  1. Install the deck board.