INTAKE MANIFOLD > INSTALLATION |
| 1. INSTALL INTAKE MANIFOLD |
Install the gasket to the intake manifold.
Temporarily install the intake manifold onto the cylinder head sub-assembly with the 3 bolts and 2 nuts.
![]() |
Tighten the 3 bolts and 2 nuts in the order shown in the illustration.
Install the oil level dipstick.
Engage the wire harness clamp and install the wire harness to the intake manifold.
Install the 2 wire harness brackets with the 2 bolts.
| 2. CONNECT UNION TO CONNECTOR TUBE HOSE |
Connect the union to connector tube hose to the intake manifold.
| 3. CONNECT VENTILATION HOSE |
Connect the ventilation hose to the intake manifold.
| 4. INSTALL STUD BOLT |
Using a "TORX" socket wrench E6, install the 3 stud bolts to the intake manifold.
| 5. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY |
| 6. INSPECT INTAKE SYSTEM |