Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)
(Click here)


2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
(Click here)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)


    C235152E01
  1. Put the matchmarks on the clutch cover assembly and the flywheel sub-assembly.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen the 6 bolts one turn at a time until spring tension is released.

  1. Remove the 6 bolts and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)
  1. Remove the clutch disc assembly.

    NOTICE:
    Keep the lining part of the clutch disk and the surfaces of the pressure plate and flywheel free of oil and foreign matter.



5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)


A166739E01
  1. Hold the crankshaft with SST.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A154898E05
  1. Remove the 6 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.



6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


A166739E01
  1. Hold the crankshaft with SST.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A166741
  1. Remove the 6 bolts and flywheel.



7. REMOVE REAR ENGINE OIL SEAL


A166928E05
  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Cut Position

  1. Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.

    NOTICE:
    After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.