REAR CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle) |
| 2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle) |
| 3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle) |
![]() |
Put the matchmarks on the clutch cover assembly and the flywheel sub-assembly.
| *a | Matchmark |
Loosen the 6 bolts one turn at a time until spring tension is released.
Remove the 6 bolts and pull off the clutch cover assembly.
| 4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle) |
Remove the clutch disc assembly.
| 5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle) |
![]() |
Hold the crankshaft with SST.
![]() |
Remove the 6 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.
| 6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Hold the crankshaft with SST.
![]() |
Remove the 6 bolts and flywheel.
| 7. REMOVE REAR ENGINE OIL SEAL |
![]() |
Using a knife, cut off the lip of the oil seal.
| *1 | Protective Tape |
| *a | Cut Position |
Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.