Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control indicator light turns on.

INSPECTION PROCEDURE

NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE CONTROL INDICATOR LIGHT)
  1. Using the intelligent tester, perform the Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise control indicator light
    OFF/ON
    Vehicle is stopped and engine is idling

    OK:
    Indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL INDICATOR LIGHT)
  1. Using the intelligent tester, read the Data List (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Indicator M-CPU
    Cruise control indicator (Main CPU) / OFF or ON
    OFF: Cruise control indicator light off
    ON: Cruise control indicator light on
    -

    OK:
    The display is as specified in the normal condition column.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 2NZ-FE)
    B
    NG (for 1NZ-FE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)