CANISTER > REMOVAL |
| 1. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board.
| 2. REMOVE SPARE WHEEL COVER |
![]() |
Remove the spare wheel cover.
| 3. REMOVE REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type) |
| 4. REMOVE REAR SEAT ASSEMBLY RH (for 60/40 Split Seat Type) |
| 5. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 6. REMOVE REAR SEATBACK CENTER HINGE SUB-ASSEMBLY (for 60/40 Split Seat Type) |
![]() |
Remove the 2 bolts and the rear seatback center hinge sub-assembly.
| 7. DISCHARGE FUEL SYSTEM PRESSURE |
| 8. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 9. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Spread the tip of the tube joint clip, and pull it out in the direction of the arrow.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | O-Ring |
| *4 | Nylon Tube |
| *5 | Fuel Suction Plate |
![]() | Widen |
![]() | Pull Out |
Disconnect the fuel main tube from the fuel tank assembly.
| 10. SEPARATE NO. 2 FUEL EMISSION TUBE |
![]() |
Remove the clip and disconnect the No. 2 fuel emission tube from the fuel suction plate.
| 11. SEPARATE NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY |
![]() |
Disconnect the No. 1 canister outlet hose sub-assembly from the fuel suction plate.
| 12. REMOVE FUEL PUMP GAUGE RETAINER |
![]() |
Install SST to the fuel pump gauge retainer.
Temporarily install plate and claw to the fuel pump gauge retainer.
Press claw against the rib of the fuel pump gauge retainer, and tighten bolt.
Install SST handle.
![]() |
While making sure that SST does not rise up, slowly turn handle and loosen the fuel pump gauge retainer.
While holding down the fuel suction tube assembly, remove the fuel tank pump gauge retainer.
| 13. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
![]() |
After bending up the tip of the fuel pump filter and pulling it out, pull out the arm of the fuel sender gauge assembly, and remove the fuel suction tube assembly from the fuel tank.
| *1 | Fuel Pump Filter |
![]() | Direction to Bend |
| 14. REMOVE FUEL SUCTION TUBE SET GASKET |
![]() |
Remove the fuel suction tube set gasket.
| 15. DRAIN FUEL |