INSTALLATION
LOWER SUSPENSION ARM BUSHING
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process .
1. Install the new lower suspension arm bushings into the lower suspension arm using tools 8862-3 (driver)(1), 8862-4 (receiver)(3), 8862-5 (spacer)(2) and the bearing with the threaded rod 8839 (4) making sure to properly orient the bushing in the suspension arm.
2. Remove the suspension arm from the vise.
3. Install the lower suspension arm (Refer to 2 - SUSPENSION/REAR/LOWER CONTROL ARM - INSTALLATION).
UPPER SUSPENSION ARM BUSHING
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process .
1. Install the new upper suspension arm bushings into the upper suspension arm using tools 8835-3 (receiver)(2), 8860-2 (driver)(3) and the bearing with the threaded rod 8838 (1) making sure to properly orient the bushing in the suspension arm.
2. Remove the suspension arm from the vise.
3. Install the upper suspension arm (Refer to 2 - SUSPENSION/REAR/UPPER CONTROL ARM - INSTALLATION).