REMOVAL
LOWER SUSPENSION ARM BUSHING
1. Remove the lower suspension arm (Refer to 2 - SUSPENSION/REAR/LOWER CONTROL ARM - REMOVAL).
2. Secure the suspension arm in a vise.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process .
3. Install special tools 8862-4 (receiver)(2), 8862-5 (spacer)(3) and 8862-1 or 8862- 2 (driver)(4) with the threaded rod 8839 (1) and the bearing as shown
4. Press out the bushing.
UPPER SUSPENSION ARM BUSHING
1. Remove the upper suspension arm (Refer to 2 - SUSPENSION/REAR/UPPER CONTROL ARM - REMOVAL).
2. Secure the suspension arm in a vise.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process .
3. Install special tools 8853-3 (driver)(1), 8860-1 (receiver)(2) and with the threaded rod 8838 (3) and the bearing as shown
4. Press out the bushing.