DIAGNOSIS SYSTEM

1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning light or multi information display, by reading the multi information display, or by connecting the intelligent tester.
   
2. This system has a signal check function (Click here).
   The DTC can be read by connecting the intelligent tester and observing the blinking pattern of the ABS warning light or by reading the multi information display.
   

NOTICE:

When releasing the parking brake, set chocks to hold the vehicle for safety.

HINT:

When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

When the engine switch is turned on (IG). Check that the ABS, BRAKE warning lights, and master caution, SLIP indicator lights come on for approximately 3 seconds. Make sure that the message on the multi information display changes from "CHECK" to "COMPLETE" for 2 seconds.

HINT:

If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS, BRAKE and VSC warning light circuits and SLIP indicator light circuits.