|
Last Modified: 11-27-2007 |
1.6 A |
|
Service Category: Brake |
Section: Brake Control/Dynamic Control System |
|
Model Year: 2008 |
Model: LX570 |
Doc ID: RM000000SS601SX |
|
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION (2008 LX570) |
INSTALLATION
1. INSTALL STEERING ANGLE SENSOR
|
(a) Align the installation holes on the steering angle sensor with the pins on the spiral cable.
|
(b) Attach the 6 claws to install the steering angle sensor to the spiral cable.
2. INSTALL SPIRAL CABLE SUB-ASSEMBLY
3. INSTALL UPPER STEERING COLUMN COVER
4. INSTALL LOWER STEERING COLUMN COVER
5. ADJUST SPIRAL CABLE
6. INSTALL STEERING WHEEL ASSEMBLY
7. INSTALL STEERING PAD
8. INSTALL LOWER NO. 2 STEERING WHEEL COVER
9. INSTALL LOWER NO. 3 STEERING WHEEL COVER
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
-
Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter
.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
11. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light
.
|