| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Engine Mechanical | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002BOF00EX |
| Title: 3UR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL FAN AND GENERATOR V BELT
|
(a) Set the V belt onto every part. |
(b) While turning the belt tensioner counterclockwise, remove the bar.
NOTICE:
Make sure that the V belt is properly set to each pulley.
|
(c) After installing the belt, check that it fits properly in the ribbed grooves. HINT:
Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley. |
2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
5. INSTALL V-BANK COVER SUB-ASSEMBLY
6. INSTALL UPPER RADIATOR SUPPORT SEAL
7. INSTALL ENGINE ROOM SIDE COVER LH
8. INSTALL ENGINE ROOM SIDE COVER RH
|
|