| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Engine Control | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002H5D00DX |
| Title: 3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4. REMOVE ENGINE ROOM SIDE COVER LH
5. REMOVE ENGINE ROOM SIDE COVER RH
6. REMOVE UPPER RADIATOR SUPPORT SEAL
7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
8. REMOVE V-BANK COVER SUB-ASSEMBLY
9. REMOVE AIR CLEANER HOSE ASSEMBLY
10. REMOVE AIR CLEANER ASSEMBLY
11. REMOVE FAN AND GENERATOR V BELT
12. DRAIN POWER STEERING FLUID
13. REMOVE FRONT WHEEL
14. REMOVE FRONT FENDER APRON SEAL FRONT RH
15. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
|
(a) Disconnect the connector. |
(b) Remove the nut, bolt and sensor.
16. REMOVE POWER STEERING OIL PRESSURE SWITCH
|
(a) Disconnect the switch connector. |
(b) Using a 24 mm deep socket wrench, remove the oil pressure switch.
(c) Remove the O-ring.
|
|