Home › Steering › Power Assist Systems › VANE PUMP
Last Modified: 11-27-2007 1.6 A
Service Category: Steering Section: Power Assist Systems
Model Year: 2008 Model: LX570 Doc ID: RM000002H5D00GX
Title: POWER ASSIST SYSTEMS: VANE PUMP: REMOVAL (2008 LX570)

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

w/ Navigation System:

NOTICE:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE FRONT WHEEL RH

3. REMOVE FRONT FENDER APRON SEAL FRONT RH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL (2008 LX570)+

4. REMOVE V-BANK COVER SUB-ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: REMOVAL (2008 LX570)+

5. REMOVE AIR CLEANER HOSE ASSEMBLY 3UR-FE INTAKE / EXHAUST: INTAKE MANIFOLD: REMOVAL (2008 LX570)+

6. REMOVE AIR CLEANER ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: REMOVAL (2008 LX570)+

7. REMOVE FAN AND GENERATOR V BELT 3UR-FE ENGINE MECHANICAL: DRIVE BELT: REMOVAL (2008 LX570)+

8. DRAIN POWER STEERING FLUID

9. DISCONNECT SUCTION HOSE



(a) Slide the clip and disconnect the suction hose from the vane pump.

10. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR



(a) Detach the wire harness clamp and disconnect the connector.

11. DISCONNECT PRESSURE FEED TUBE

(a) Remove the bolt and disconnect the pressure feed tube.

(b) Remove the gasket.

12. REMOVE VANE PUMP ASSEMBLY



(a) Remove the 2 bolts and vane pump.