| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Axle/Differential | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002HW900AX |
| Title: AXLE AND DIFFERENTIAL: FRONT DIFFERENTIAL CARRIER OIL SEAL: REPLACEMENT (2008 LX570) | ||
REPLACEMENT
1. DRAIN DIFFERENTIAL OIL
2. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY
(a) Remove the differential carrier
.
3. REMOVE DIFFERENTIAL EXTENSION FLANGE TUBE
4. REMOVE FRONT DRIVE PINION COMPANION FLANGE FRONT NUT
5. REMOVE FRONT DRIVE PINION COMPANION FLANGE FRONT SUB-ASSEMBLY
6. REMOVE FRONT DIFFERENTIAL CARRIER OIL SEAL
|
(a) Using SST, remove the oil seal. SST: 09308-10010 |
7. REMOVE FRONT DIFFERENTIAL DRIVE PINION OIL SLINGER
8. REMOVE FRONT DIFFERENTIAL CROSS SHAFT BEARING RETAINER
9. REMOVE FRONT NO. 1 DIFFERENTIAL CASE SUB-ASSEMBLY
10. REMOVE DIFFERENTIAL DRIVE PINION
11. REMOVE FRONT DRIVE PINION FRONT RADIAL BALL BEARING
12. REPLACE FRONT DIFFERENTIAL DRIVE PINION BEARING SPACER
(a) Replace the bearing spacer with a new one.
13. TEMPORARILY INSTALL DIFFERENTIAL DRIVE PINION
14. INSTALL FRONT NO. 1 DIFFERENTIAL CASE SUB-ASSEMBLY
15. INSTALL FRONT DIFFERENTIAL CROSS SHAFT BEARING RETAINER
16. INSTALL FRONT DRIVE PINION FRONT RADIAL BALL BEARING
17. INSTALL FRONT DIFFERENTIAL DRIVE PINION OIL SLINGER
18. INSTALL FRONT DIFFERENTIAL CARRIER OIL SEAL
|
(a) Using SST and a hammer, tap in a new oil seal. SST: 09502-12010 SST: 09316-60011 09316-00041 Standard oil seal depth: 5.6 to 6.6 mm (0.221 to 0.260 in.) |
(b) Coat the lip of the oil seal with MP grease.
19. INSTALL FRONT DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY
20. INSPECT DIFFERENTIAL DRIVE PINION PRELOAD
21. INSPECT TOTAL PRELOAD
22. STAKE FRONT DRIVE PINION COMPANION FLANGE FRONT NUT
23. INSTALL DIFFERENTIAL EXTENSION FLANGE TUBE
24. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY
(a) Install the front differential carrier
.
25. ADD DIFFERENTIAL OIL
|
|